RIDGID DP1500 Spécifications télécharger pdf (Page 24)

Basic Drill Press Operation (continued)

Tilting Table

To use the table in a bevel (tilted) position, loosen the set

screw under table bevel lock with hex “L” wrench. Loosen

bevel lock bolt with the 24mm flat wrench (included).

Tilt table to desired angle by reading bevel scale.

Retighten bevel lock and set screw.

WARNING: To reduce the risk of injury from spin-

ning work or tool breakage, always clamp work-

piece and backup material securely to table before

operating drill press with the table tilted.

To return table to original position: Loosen set screw and

bevel lock, tilt table back to 0° on bevel scale and

retighten set screw, then tighten bevel lock.

Hole Location

Make a dent in the workpiece where your want the hole,

using a center punch or a sharp nail.

Before turning the switch on, bring the drill down to the

workpiece lining it up with the hole location.

Feeding

Pull down on the feed handles with only enough effort to

allow the drill to cut.

Feeding too slowly might cause the drill to burn. Feeding

too rapidly might stop the motor, cause the belt or drill to

slip, tear the workpiece loose or break the drill bit.

When drilling metal, it may be necessary to lubricate the

tip of the drill with cutting oil or motor oil to prevent burn-

ing of the drill tip.

Adjustments

WARNING: For your own safety turn switch “OFF”

and remove plug from power source outlet before

making any adjustments. To reduce the risk of

injury from thrown parts due to spring release, fol-

low instructions carefully and wear eye goggles.

Quill Return Spring

NOTE: The return spring tension is set at the factory and

should not require further adjustment.

1. With the chuck at its highest possible position, turn

the depth scale clockwise until it stops and tighten the

depth scale lock. This will prevent the quill dropping

while tensioning the spring.

2. Lower table for additional clearance.

3. Work from left side of drill press.

4. Place screwdriver in lower front notch of spring cap,

and hold it in place while loosening and removing

(outer) nut only.

5. With screwdriver remaining in notch, loosen (inner)

nut (approximately 1/8") until notch disengages from

boss on head. Do not remove this nut.

6. Carefully turn screwdriver counterclockwise and

engage next notch in boss. Do not remove screw-

driver.

7. Tighten standard nut with wrench only enough to

engage boss. Do not overtighten as this will restrict

quill movement.

8. Move stop nuts and depth pointer to upper most posi-

tion and check tension while turning feed handles.

9. If there is not enough tension on spring, repeat steps

4-8 moving only one notch each time and checking

tension after each repetition.

10. Proper tension is achieved when quill returns gently

to full up position when released from 3/4” depth.

11. When there is enough tension after checking, replace

outer nut and tighten to inner nut. But do not over-

tighten against inner nut.

12. Check quill while feeding to have smooth and unre-

stricted movement. If movement is too tight, loosen

outer nut and slightly loosen inner nut until unre-

stricted. Retighten outer nut.

Bevel Lock

Set Screw

Bevel Scale

Notch

Nut

(Outer)

Nut

(Inner)

Boss

Spring

Notch

Cap

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 30 31 32

Commentaires sur ces manuels

Pas de commentaire

RIDGID DP1500 Spécifications Page 24

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques RIDGID DP1500