RIDGID DP1500 Spécifications télécharger pdf (Page 13)

Installing Feed Handles

1. Locate three (3) feed handles among loose parts.

2. Screw the feed handles into the threaded holes in the

hub and tighten.

3. Tighten feed handles using M24 wrench.

Installing the Chuck/Arbor Assembly

1. Clean the tapered surfaces on the arbor and spindle

with a clean cloth. Make sure there are no foreign par-

ticles sticking to these surfaces. The slightest piece of

dirt on these surfaces will prevent the arbor from seat-

ing properly. This will cause the drill to “wobble”.

2. Slide arbor into spindle on drill press.

3. Push up on chuck/arbor assembly as you rotate them.

You will feel rectangular end of arbor slip into a notch in

the spindle.

WARNING: Make sure the rectangular end of the

arbor has slipped into the notch in the spindle

before going on the step 4. Failure to follow this

direction may allow the chuck to come loose dur-

ing operation, fly out and hit the operator.

Hub

Feed

Handle

Tighten Using

M24 Wrench

Quill

Spindle

Tapered Surface

Arbor Tapered

Surface

Chuck Sleeve

Chuck Body

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 31 32

Pas de commentaire

RIDGID DP1500 Spécifications Page 13