RIDGID RP 210 Manuel de l'opérateur télécharger pdf (Page 11)

Figure 11 – Pressure Release Button

Inspecting The Pressed Connection

1. Inspect the pressed fitting. If the fitting is supplied with

a control ring and/or a control label by the fitting

manufacturer, remove it. Control rings and labels

are supplied by the manufacturer to indicate that the

fitting has not yet been pressed. Removal of the

control ring and label indicates to others that the

connection has been pressed.

Look for the following:

• Excessive misalignment of the tubes. Note that a

slight amount of misalignment at the pressed con-

nection is considered normal.

• Tubes that are not fully inserted into the fitting –

double check the insertion marks made on the

tube to see that they are still aligned with the end of

the fitting.

• Incorrect jaw or ring alignment with the fitting con-

tour, distorted or deformed fitting.

• Any other issues per the fitting manufacturer.

If any of these problems are found, then removal of

the fitting is required and a new fitting and tube will

need to be prepared and pressed in its place.

2. Test system in accordance with normal practice and

local codes.

3. See fitting system’s operator’s manual for specific

inspection criteria.

Cold Weather Operation

As temperature drops, all batteries experience perfor-

mance degradation. The lowest temperature at which a

tool and 1.1Ah battery can make a complete press is

15°F (-10°C). At temperatures below this, the 1.1Ah bat-

tery is not able to provide sufficient power to the press tool.

Figure 9 – Installing Press Ring Onto Fitting

Figure 10 – Attaching Actuator To Press Ring

NOTE! If yellow LED service indicator blinks, the tool

should be sent to a RIDGID Authorized Service

Center for required maintenance. The tool will not

run if it is not serviced within 2,000 cycles after the

first blinking yellow LED.

The RP 210-B Press Tool will turn off auto-

matically if the battery is too low to successfully com-

plete a pressed connection. This will be indicated by

blinking of the green LED. A fully charged battery should

be inserted in the tool and the pressed connection should

be repeated as indicated above.

To retract the rollers and remove the tool from the fitting if

battery dies or tool malfunctions during pressed connec-

tion, it is necessary to press the pressure release button

on the right hand side of the tool

(Figure 11).

If this hap-

pens, the connection will need to be pressed again to

insure completion.

8. After cycle is complete, squeeze actuator arms to

open and separate actuator from press ring. Remove

the press ring from fitting by manually grasping ring

halves and opening assembly. Avoid any sharp edges

which may have formed on fitting during pressing

operation.

Ridge Tool Company 9

RP 210 Press Tool

NOTICE

Pressure Release

Button

1 2 ... 6 7 8 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

RIDGID RP 210 Manuel de l'opérateur Page 11

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques RIDGID RP 210