RIDGID RP 210 Manuel de l'opérateur télécharger pdf (Page 14)

RP 210 Press Tool

RP 210 Diagnostic Codes

LED Status Description Icon

Green

Glows Tool ON.

Blinks Out of acceptable voltage range.

— Replace battery with a fully charged battery.

Red Blinks Attachment mounting pin not fully engaged. Insert pin.

Glows If only red light is ON, Out of temperature range 15°F (-10°C) to 122°F (50°C).

Yellow Blinks Service indicator after 30,000 cycles. NOTE: Tool will lock after 32,000 cycles.

Glows Machine is locked – Service after 32,000 cycles or after a malfunction.

SYMPTOM POSSIBLE REASONS SOLUTION

Yellow LED glows con-

tinuously and tool will

not begin press cycle

when trigger switch is

depressed.

Red LED blinks repeated-

ly and tool will not begin

press cycle when trigger

switch is depressed.

Yellow LED glows when

tool is turned ON.

Jaws are locked onto

fitting.

The pressed connections

produced are not com-

plete.

Troubleshooting

(Continued)

Scheduled maintenance/recalibration is manda-

tory after 32,000 presses. Tool is “locked” and

will not function until tool is serviced.

Attachment mounting pin not fully closed.

Tool malfunction detected.

Press was not successfully completed.

Used wrong jaws for the tube size or material.

The tool was not square to the tube.

Jaw contour was not aligned with the fitting contour.

Tool is in need of repair.

Return to Test Equipment Depot

Insert attachment mounting pin to the fully closed

position.

Remove and reinsert fully charged battery. Be sure

to repress fitting. If LED’s continue to glow, contact

Ridge Tool Company, Technical Service Depart-

ment at (800) 519-3456 for nearest Authorized

Service outlet.

Push pressure release valve to remove jaws from fit-

ting. Inspect and repress fitting.

Install the correct jaws.

Redo the joint with new fitting and new tube.

Make sure that the tool is square to the tube.

Redo the joint with new tube and new fitting.

Make sure the jaw contour is aligned with the

fitting contour.

Figure 12 – LED Diagnostic Codes

Test Equipment Depot - 800.517.8431 - 99 Washington Street Melrose, MA 02176

TestEquipmentDepot.com

1 2 ... 9 10 11 12 13 14

Commentaires sur ces manuels

Pas de commentaire

RIDGID RP 210 Manuel de l'opérateur Page 14

Commentaires sur ces manuels

Produits connexes et manuels pour Outils électriques RIDGID RP 210