RIDGID 120V Spécifications télécharger pdf (Page 66)

66

Adjustments

WARNING: For your own safety,

turn switch “OFF” and remove

plug from power source outlet

before making any adjustments.

Miter Gauge

NOTE: The graduations are manufac-

tured to very close tolerances which pro-

vide ample accuracy for fine

woodworking. In some cases where

extreme accuracy is required, when mak-

ing angle cuts, for example, make a trial

cut and then recheck it.

There are adjustable screw stops for the

stop pin at 0° and 45° right and left posi-

tions for conveniently setting the miter

gauge to cut miters at these standard

angles.

Adjusting Stop Screws

A. Loosen lock nut of screw for 0° stop.

B. Place 90° square against the miter

gauge bar and the face of the miter

gauge head.

C. If adjustment is needed loosen han-

dle of miter gauge. Adjust miter

gauge head flush to square. Tighten

lock knob.

D. Adjust stop screw until it rests

against the stop pin and tighten lock

nut.

E. Adjust 45°, left and right using a 45°

triangle or a protractor of a square

using the above procedure.

The miter gauge head should swivel

smoothly on the bar after the knob is loos-

ened. To adjust this swivel movement:

A. Loosen the knob.

B. Loosen set screw with a 2.5mm hex

wrench.

C. If the head is too loose turn the flat-

head screw in a clockwise direction.

If the head is too tight and will not

swivel smoothly turn the flathead

screw counterclockwise.

D. Tighten set screw.

Bar

Knob

Miter Gauge

Head

Stop Pin

Pointer

Adjustment

Screw

Flat Head

Screw

Set Screw

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 83 84

Commentaires sur ces manuels

Pas de commentaire