RIDGID 120V Spécifications télécharger pdf (Page 53)

53

Making the handle:

• Miter crosscut a piece of 3/4 inch thick

plywood to shape and size shown:

NOTE: The mitered corners can be any

size that looks like the drawing (about 1-1/2"

by 1-1/2").

Putting it Together

• Using good quality woodworking glue,

glue the 3/8" x 3/8" x 2-1/2" piece strip

saved earlier to the base as shown.

IMPORTANT: Do not use nails or screws.

This is to prevent dulling of the sawblade

in the event you cut into the push block.

• Position the handle at the center of the

plywood base as shown. Fasten them

together with glue and wood screws.

IMPORTANT: Make sure the screw heads

do not stick out from the bottom of the

base, they must be flush or recessed. The

bottom must be flat and smooth enough

to slide along the auxiliary fence you are

now ready to make.

Auxiliary Fence

Making the base:

• Start with a piece of 3/8 inch plywood

at least 5-1/2 inches wide or wider and

30 inches long or longer.

• Cut the piece to shape and size shown:

Making the side:

• Start with a piece of 3/4 inch plywood

at least 2-3/8 inches wide or wider and

27 inches long or longer.

• Cut the piece to shape and size shown:

Putting it together:

• Put the pieces together, as shown:

IMPORTANT: Make sure the screw heads

do not stick out from the bottom of the

base, they must be flush or recessed. The

bottom must be flat and smooth enough

to rest on the saw table without rocking.

Cutting Out the Base

Cutting Out the Side

Finished Auxiliary Fence

3/8" Plywood Base

3/4" Plywood Handle

Screw Head Must Be

Flush Or Recessed

Glue

Only

3/8" Thick Plywood Base

30"

2-5/8

5-1/2

3-1/2

3/4" Thick Plywood Side

27"

3/4" Plywood

3/8"

4-3/4"

This face and this edge

must be parallel

1-1/4

Plywood

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 83 84

Commentaires sur ces manuels

Pas de commentaire