RIDGID 120V Spécifications télécharger pdf (Page 51)

51

• Feed the workpiece into the saw

only fast enough to let the blade cut

without bogging down or binding.

Before freeing jammed material.

• Turn switch “OFF”.

• Wait for all moving parts to stop.

• Unplug the saw.

• Check blade, spreader and fence

for proper alignment before starting

again.

To reduce the risk of throwback of

cut off pieces.

• Use the guard assembly.

To remove loose pieces beneath or

trapped inside the guard.

• Turn saw “OFF”.

• Remove switch key.

• Wait for blade to stop before lifting

the guard.

Before Leaving The Saw.

• Turn the saw off.

• Wait for blade to stop spinning.

• Unplug the saw.

• Make workshop child-proof. Lock

the shop. Disconnect master

switches. Remove the yellow switch

key. Store it away from children and

others not qualified to use the tool.

Work Feed Devices

Before cutting any wood on your saw,

study all of the "Basic Saw Operations".

As you learn new table saw woodworking

techniques, you’ll see that many types of

cuts need different supportand feeding

devices, known as jigs or fixtures.They

can help you make cuts more accurately.

By helping to steady the workpiece and

keep you away from the blade, they can

help you safely use your saw for certain

cuts.

Many people custom build their own jigs

and fixtures. Jigs and fixtures are often

designed for a particular cut.

You can use your table saw to easily

make many jigs and fixtures. To get you

started, we've included instructions for

some simple ones. After you have made a

few practice cuts, make up these jigs

before starting any projects.

The use of these devices is explained in

"Basic Saw Operation" section.

Attaching Wood Face Board

1. A -T slot is provided in the rip fence for

attaching a wood facing when using

the dado head, or molding head, feath-

erboards or other jigs and fixtures.

2. Select a piece of smooth straight wood

approximately 3/4 inch thick, and the

same length as the rip fence.

3. To fasten wood face to the fence use the

three 1/4"20 x 3/4" square head bolts, lock-

washers, flat washers and nuts supplied.

Counterbore three 3/4" dia. holes 3/8"

deep into the 3/4" board at the dimen-

sion shown. Avoid placing screws

directly over blade.

4. Drill a 9/32" clearance hole through the

board at each counterbore location.

Kerfs About

5/16" Apart

24"

5"

4-1/2"

8"

Slightly Less Than Thickness

Of Workpiece Up to 3/8"

90° Notch

Grain

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 83 84

Commentaires sur ces manuels

Pas de commentaire