Ridgid Table Saw Manuel d'utilisateur télécharger pdf (Page 56)

Troubleshooting

WARNING: For your own protection, turn switch “OFF” and always

remove plug from power source outlet before troubleshooting.

General

Trouble Probable Cause Remedy

Excessive

Vibration

1. Blade out of balance or

damaged

1. Replace blade.

Cannot make

square cut when

crosscutting.

1. Miter gauge not

adjusted properly.

1. See “Adjustments” section “Miter

Gauge.”

Cut binds, burns

or stalls motor

when ripping.

1. Dull blade or improper

tooth set.

2. Blade is heeling.

3. Warped board

4. Rip fence not parallel

to blade.

5. Spreader out of align-

ment.

1. Sharpen or replace blade.

2. See “Alignment” section, “Heeling

Adjustment”.

3. Make sure concave or hollow side is

facing “down” feed slowly.

4. See “Alignment” section, “Aligning

Rip Fence.”

5. See “Alignment” section, “Installing

Blade Guard.”

Cut not true at

90° or 45° bevel

positions.

1. Indexes not properly

adjusted.

1. See “Alignment” section, “Blade Tilt,

or Squareness of Blade to Table”.

Elevating hand-

wheel turns

hard.

1. Sawdust on threads of

elevating screw.

1. See “Maintenance” and “Lubrication”

sections.

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 67 68

Commentaires sur ces manuels

Pas de commentaire

Ridgid Table Saw Manuel d'utilisateur Page 56

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ridgid Table Saw