Ridgid Table Saw Manuel d'utilisateur télécharger pdf (Page 22)

Alignment (continued)

NOTE: Always review the section "Check-

ing Blade Parallel to the Miter Gauge

Groove" before proceeding with this sec-

tion.

7. Loosen 1/2 turn the four alignment

screws in the top of table next to the

sawblade. This will allow the mecha-

nism below the table to be shifted

sideways.

CAUTION: Blade tips are sharp,

to move, grasp blade as shown

to avoid injury.

8. Push on side of blade and move it to

either the right or left as needed to

make the square touch the same

amount front and rear. Tighten one

screw.

9. Check with square to determine if

marked tooth touches square by the

same amount at front and rear.

If it does, alternately tighten the other

three screws.

If it does not, loosen screw and move

blade the required amount.

10. Recheck blade clearance to table

insert to make sure blade does not hit

at either 90 or 45 degree blade tilt.

Alignment

Screws

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 67 68

Pas de commentaire

Ridgid Table Saw Manuel d'utilisateur Page 22