Ridgid AC99401 Manuel d'utilisateur télécharger pdf (Page 7)

WORKSTAND SET-UP

See Figures 4 - 5.

Before You Start

n If a miter saw is already assembled to the stand, make

sure that it is securely attached to the stand per the

instructions in this manual.

n If a compound miter saw is already assembled to the

stand, make sure to place the blade 90° to the table (if

applicable). Miter the blade to the right as far as it will

go, place the blade in the “locked down” position, and

lock all knobs and levers.

n If a slide compound miter saw is already assembled to

the stand, follow the above steps plus slide the head/

blade assembly to the front of the saw and lock the slide

rails.

SETTING UP

n From the upright position, hold the leg cross bar and pull

the locking pin.

n Lift legs up until the locking pin locks in place.

n Lower unit until the legs rest on the floor.

n Stand at wheel end of unit, grasp the lift handle/lock

lever. Squeeze lock lever and raise the table to a position

just above horizontal.

CAUTION:

Do not lift by any part of the miter saw that is

attached to the workstand. Failure to do so may

result in possible injury and damage the tool.

ASSEMBLY

WARNING:

To avoid serious personal injury when lifting, bend

your knees so you can lift with your legs, not your

back.

n The sliding legs will follow tracks on the underside of the

table to their engaged position near the handle end of

the table.

n Return table to horizontal position. The table should

now rest firmly on top of the sliding legs. If not, repeat

“pull up and set down” motion.

n Release lift handle/lock lever.

NOTE: You may need to adjust the speed at which you raise

the table in order to get the sliding leg to catch in the notch.

WARNING:

To reduce the risk of injury, make sure sliding leg

is secured in the notch by the lock lever. Failure to

latch may cause stand to fall in use.

UPRIGHT POSITION

PULL

LOCKING PIN

LEG

CROSSBAR

LIFT HANDLE/

LOCK LEVER

SLIDING LEG

Fig. 4

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Ridgid AC99401 Manuel d'utilisateur Page 7

Commentaires sur ces manuels

Produits connexes et manuels pour Scies à moteur Ridgid AC99401