20 – English – CS6
Line Tracing the Push Cable
You can locate the path of a pipe by line tracing the push
cable. This is especially useful for inspecting non-metal-
lic or non-conductive pipes. Line trace the push cable by
using a transmitter to induce current onto the push cable.
Note: The CS6 must be powered on and connected to a
SeeSnake camera reel and transmitter to line trace the
push cable.
To line trace the push cable, follow these steps:
1. Push the transmitter’s ground stake into the ground
and clip one of the transmitter’s leads to it.
2. Clip the other lead to the transmitter clip-on terminal
on the back of the CS6.
3. Power on the transmitter and set your desired fre-
quency. For best results, use frequencies 33 kHz
and higher.
4. Power on the receiver and set it to the same fre-
quency as the transmitter.
5. Trace the line.
Note: For additional instructions on line tracing, refer to
the manuals for the transmitter and receiver models you
are using.
Commentaires sur ces manuels