RIDGID 300 Compact Manuel de l'opérateur télécharger pdf (Page 10)

8. Tighten the feedscrew handle slowly and continu-

ously until the pipe is cut. Do not force the cutter into

the workpiece.

9. Release the foot switch and remove your foot from

the housing.

10. Swing pipe cutter back to the UP position.

Reaming Pipe With No. 344 Reamer

1. Move reamer arm into DOWN position.

2. Check the directional switch to insure it is in the FOR

(Forward) position. Depress and hold the foot switch

down with left foot.

3. Position reamer into pipe and complete reaming

by exerting pressure on handwheel

(Figure 4).

Figure 4 – Reaming Pipe With No. 344 Reamer

4. Retract reamer and return reamer to UP position.

5. Release foot switch and remove your foot from the

housing.

Threading Pipe or Rod With

Quick-Opening, Self-Opening

or Semi-Automatic Die Head

1. Install die set. Refer to die installation procedure.

2. Swing cutter and reamer to UP position.

3. Swing die head to DOWN position with throwout

lever set to CLOSE position.

4. Check directional switch to insure it is in the FOR

(Forward) position. Depress and hold the foot switch

down with left foot.

NOTE! 300 Compact Machines have an automatic oil-

ing system that brings oil to the work through the

die head. Oil flow can be adjusted with oil flow

control valve located on back side of carriage

(Figure 5).

Figure 5 – Oil Flow Control

5. Turn carriage handwheel to bring dies against end of

pipe. Slight pressure on handwheel will start dies

(Figure 6)

Figure 6 – Threading Pipe With No. 811-A Quick

Opening Die Head

6. Quick-Opening 811A Die Head

(Figure 7)

– When

thread is completed, raise throwout lever to open

position, retracting dies.

Self-Opening 815A Die Head

(Figure 8)

– When

die head trigger contacts end of pipe, throwout lever

is automatically opening.

Semi-automatic die head

(Figure 9)

– When the end

of the pipe being threaded is flush with the end of the

number 1 die, hit the handle for the dies to release the

pipe.

300 Compact Pipe and Bolt Threading Machine

Increase Flow

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 54 55

Commentaires sur ces manuels

Pas de commentaire

RIDGID 300 Compact Manuel de l'opérateur Page 10

Commentaires sur ces manuels

Produits connexes et manuels pour Machines à coudre RIDGID 300 Compact