RIDGID R8804 Manuel d'utilisateur télécharger pdf (Page 15)

- Make sure they are level (see gure 7).

Cover the seat which you have already installed to protect it

against drilling dust.

- Drill the holes in the wall (drilling diameter = 10 mm) and

t the plate preferably using the screws included in the stan-

dard tool set (except for R6600 model)

Use the steel sections included in the tool set to hide the

xing screws (see gure 8)

Adjust to the right leg height by unscrewing the adjustable

foot supports (if ordered) (see gure 9)

l Fitting the support legs after assembly.

- You have to order the adjustable support legs

corresponding to the chosen height (R855, R860, R865)

- Drill in the mark located on the right side of the seat to

insert the support rod (see gure 10).

- Take the plastic caps off the seat underside to t the sup-

port legs tubes. (see gure 11)

- Screw the tubes and adjust to the right leg height by

screwing / unscrewing.

l Folding the seat

The seat can easily be lowered and raised. When in raised po-

sition, the seat should remain rmly in position. If not, please

consult your dealer.

Figure 9

Figure 8

Figure 7

Figure 10

Figure 11

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 33 34

Pas de commentaire

RIDGID R8804 Manuel d'utilisateur Page 15